Epson N10 Waste Ink Counter Reset

The Epson N10 is a widely used Epson printer. Like many Epson devices, it can stop printing when the internal waste ink counter reaches its predefined limit.

The Epson N10 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Understanding the Epson N10 Waste Ink Counter

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson N10 waste counter reset in minutes.

Common Symptoms

• Printer refuses to print even with ink available
• Epson Status Monitor shows maintenance warning
• Blinking lights and blocked jobs
• Device is locked until reset is performed

Three Steps to Restore Epson N10 Printing

1. Step 1: Use a Windows PC (7–11) with Internet access. Connect Epson N10 via USB (Wi-Fi reset is not supported).
2. Step 2: Start Wic Reset Connect in Administrator mode and wait until Epson N10 appears in the device list.
3. Step 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson N10.

Most Epson N10 waste counter resets finish in ~1–2 minutes.

System Requirements

• Valid Wic Reset Connect reset key
• USB connection required (Wi-Fi reset not supported)
• Stable Internet connection during reset
• Windows 7/8/10/11 PC

If the Printer Is Not Detected

• Close Epson Status Monitor or other printer utilities.
• Run the app as Administrator.
• Temporarily disable VPN/proxy if validation fails.
• Try another USB cable (some cables are charge-only).
• Use a direct USB connection (avoid hubs).

Frequently Asked Questions