Epson L800 Waste Ink Counter Reset

The Epson L800 delivers reliable printing, but periodic maintenance routines can increase the waste ink counter and eventually trigger a ‘Service Required’ lock.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson L800 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Understanding the Epson L800 Waste Ink Counter

With Wic Reset Connect, you can reset the Epson L800 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

How the Error Appears

• ‘Service Required’ / service life message in driver or utility
• Maintenance/support code (varies by model/driver)
• Printing stops after cleaning cycles
• Warning repeats after restarting the printer

Epson L800 Ink Pad Counter Reset – Quick Steps

1. Step 1: Use a Windows PC (7–11) with Internet access. Connect Epson L800 via USB (Wi-Fi reset is not supported).
2. Step 2: Run Wic Reset Connect as Administrator and confirm Epson L800 is detected.
3. Step 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson L800.

Most Epson L800 waste counter resets finish in ~1–2 minutes.

System Requirements

• Stable Internet connection during reset
• Windows 7/8/10/11 PC
• USB connection required (Wi-Fi reset not supported)
• Valid Wic Reset Connect reset key

Troubleshooting

• Use a direct USB connection (avoid hubs).
• Temporarily disable VPN/proxy if validation fails.
• Try another USB cable (some cables are charge-only).
• Run the app as Administrator.
• Close Epson Status Monitor or other printer utilities.

FAQ