Epson L351 Waste Ink Counter Reset

When the Epson L351 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

The Epson L351 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Why the Epson L351 Stops Printing (Waste Counter Limit)

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson L351 waste counter reset in minutes.

Typical Signs

• ‘Service Required’ / service life message in driver or utility
• Maintenance/support code (varies by model/driver)
• Printing stops after cleaning cycles
• Warning repeats after restarting the printer

Epson L351 Ink Pad Counter Reset – Quick Steps

1. Step 1: Connect Epson L351 to a Windows computer with a stable Internet connection using a USB cable.
2. Step 2: Run Wic Reset Connect as Administrator and confirm Epson L351 is detected.
3. Step 3: Use the key to reset the counter, wait for completion, then restart Epson L351 to finalize.

Most Epson L351 waste counter resets finish in ~1–2 minutes.

Before You Begin

• Stable Internet connection during reset
• Valid Wic Reset Connect reset key
• USB connection required (Wi-Fi reset not supported)
• Windows 7/8/10/11 PC

If the Printer Is Not Detected

• Restart printer and PC, then try again.
• Run the app as Administrator.
• Use a direct USB connection (avoid hubs).
• Try another USB cable (some cables are charge-only).
• Temporarily disable VPN/proxy if validation fails.

Frequently Asked Questions