Canon TS8051 Ink Absorber Full Reset

When Canon TS8051 triggers an ink absorber full condition, the printer may block printing as a protective measure. The solution is typically a waste ink counter reset.

During head cleaning, surplus ink is routed to internal absorber pads. Canon TS8051 monitors this via a counter and can lock printing at a threshold.

This page is prepared for Canon TS8051. Service mode instructions are shown only when a matching series procedure is known.

Typical Signs

• ‘Ink Absorber Full’ / ‘Service Required’ message
• Support/service code (varies by series)
• Printing blocked after cleaning cycles
• Reset required to continue printing

How to Enter Service Mode on Canon TS8051

If your Canon TS8051 supports service mode reset, follow the steps below before performing the counter reset.

1. Turn the printer OFF.
2. Press and hold Stop/Reset.
3. While holding Stop/Reset, press and hold Power.
4. Release Stop/Reset (keep holding Power).
5. Press Stop/Reset 5 times.
6. Release Power — the printer should enter service mode.

If it doesn’t work, repeat the sequence carefully. The press count depends on the series.

Perform the Waste Ink Counter Reset

Once the counter is cleared, Canon TS8051 should exit the locked state and printing should resume normally.

Important Notes

Resetting the counter does not physically clean the absorber pads. For heavy usage, pads may eventually need cleaning or replacement.

Download & get started

If your model does not show a service mode section, it means no matching procedure was found for its series.

FAQ