Canon TS5070 Ink Absorber Full Reset

When Canon TS5070 triggers an ink absorber full condition, the printer may block printing as a protective measure. The solution is typically a waste ink counter reset.

Inside Canon printers, absorber pads collect excess ink from cleaning and maintenance cycles. The printer uses an internal counter to estimate pad saturation.

This page is prepared for Canon TS5070. Service mode instructions are shown only when a matching series procedure is known.

What You May Notice

• Service / maintenance warning on the screen or driver
• Printer refuses to print even with ink available
• Blinking lights and queued jobs fail
• Error reappears after restart

How to Enter Service Mode on Canon TS5070

Some Canon series require entering service mode before the ink absorber counter can be reset.

1. Turn the printer OFF.
2. Press and hold Stop/Reset.
3. While holding Stop/Reset, press and hold Power.
4. Release Stop/Reset (keep holding Power).
5. Press Stop/Reset 5 times.
6. Release Power — the printer should enter service mode.

If it doesn’t work, repeat the sequence carefully. The press count depends on the series.

Reset the Ink Absorber Counter

Once the counter is cleared, Canon TS5070 should exit the locked state and printing should resume normally.

Maintenance Reminder

Resetting the counter does not physically clean the absorber pads. For heavy usage, pads may eventually need cleaning or replacement.

Reset tools and instructions

Use a reliable USB connection and follow the steps in order.

Troubleshooting

• Power-cycle the printer and try again.
• Try a different USB cable/port if using PC software.
• Close other Canon printer utilities while resetting.
• Use the correct Stop/Reset press count for your series.
• Repeat the service mode steps carefully (timing matters).