Canon TS3370S Ink Absorber Full Reset

When Canon TS3370S triggers an ink absorber full condition, the printer may block printing as a protective measure. The solution is typically a waste ink counter reset.

Ink absorber pads store waste ink during normal operation. Canon firmware tracks this using a software counter and may stop printing when it reaches the limit.

This page is prepared for Canon TS3370S. Service mode instructions are shown only when a matching series procedure is known.

What You May Notice

• Service / maintenance warning on the screen or driver
• Printer refuses to print even with ink available
• Blinking lights and queued jobs fail
• Error reappears after restart

How to Enter Service Mode on Canon TS3370S

If your Canon TS3370S supports service mode reset, follow the steps below before performing the counter reset.

1. Turn the printer OFF.
2. Press and hold Stop/Reset.
3. While holding Stop/Reset, press and hold Power.
4. Release Stop/Reset (keep holding Power).
5. Press Stop/Reset 5 times.
6. Release Power — the printer should enter service mode.

If it doesn’t work, repeat the sequence carefully. The press count depends on the series.

Perform the Waste Ink Counter Reset

After service mode is enabled (if required), the waste ink counter can be reset using a supported reset procedure/software.

Warnings

Treat the reset as a maintenance step. If your printer has extremely high usage, consider cleaning/replacing absorber pads to avoid overflow.

Need a reset solution?

Use a reliable USB connection and follow the steps in order.

Common Fixes

• Repeat the service mode steps carefully (timing matters).
• Power-cycle the printer and try again.
• Close other Canon printer utilities while resetting.
• Try a different USB cable/port if using PC software.
• Use the correct Stop/Reset press count for your series.

FAQ