Canon TR6052 Ink Absorber Full Reset

If your Canon TR6052 suddenly refuses to print and shows a maintenance or service warning, the ink absorber counter may have reached its limit.

Inside Canon printers, absorber pads collect excess ink from cleaning and maintenance cycles. The printer uses an internal counter to estimate pad saturation.

This page is prepared for Canon TR6052. Service mode instructions are shown only when a matching series procedure is known.

How to Enter Service Mode on Canon TR6052

To access maintenance functions, Canon TR6052 may need to be placed in service mode first.

1. Turn the printer OFF.
2. Press and hold Stop/Reset.
3. While holding Stop/Reset, press and hold Power.
4. Release Stop/Reset (keep holding Power).
5. Press Stop/Reset 5 times.
6. Release Power — the printer should enter service mode.

If it doesn’t work, repeat the sequence carefully. The press count depends on the series.

Reset the Ink Absorber Counter

After service mode is enabled (if required), the waste ink counter can be reset using a supported reset procedure/software.

Maintenance Reminder

Treat the reset as a maintenance step. If your printer has extremely high usage, consider cleaning/replacing absorber pads to avoid overflow.

Need a reset solution?

If your model does not show a service mode section, it means no matching procedure was found for its series.

If It Doesn’t Work

• Power-cycle the printer and try again.
• Repeat the service mode steps carefully (timing matters).
• Use the correct Stop/Reset press count for your series.
• Close other Canon printer utilities while resetting.
• Try a different USB cable/port if using PC software.

FAQ