Canon TR5053 Ink Absorber Full Reset

Canon TR5053 can lock printing when the waste ink (ink absorber) counter hits a predefined threshold. This guide explains how to reset it.

During head cleaning, surplus ink is routed to internal absorber pads. Canon TR5053 monitors this via a counter and can lock printing at a threshold.

This page is prepared for Canon TR5053. Service mode instructions are shown only when a matching series procedure is known.

How to Enter Service Mode on Canon TR5053

To access maintenance functions, Canon TR5053 may need to be placed in service mode first.

1. Turn the printer OFF.
2. Press and hold Stop/Reset.
3. While holding Stop/Reset, press and hold Power.
4. Release Stop/Reset (keep holding Power).
5. Press Stop/Reset 5 times.
6. Release Power — the printer should enter service mode.

If it doesn’t work, repeat the sequence carefully. The press count depends on the series.

Reset the Ink Absorber Counter

After service mode is enabled (if required), the waste ink counter can be reset using a supported reset procedure/software.

Warnings

Resetting the counter does not physically clean the absorber pads. For heavy usage, pads may eventually need cleaning or replacement.

Need a reset solution?

If your model does not show a service mode section, it means no matching procedure was found for its series.

Troubleshooting

• Repeat the service mode steps carefully (timing matters).
• Power-cycle the printer and try again.
• Close other Canon printer utilities while resetting.
• Try a different USB cable/port if using PC software.
• Use the correct Stop/Reset press count for your series.

FAQ