Canon MX491 Reset Ink Absorber – Complete Tutorial

Canon MX491 Ink Absorber Full Reset

The “Ink Absorber Full” / service required message on Canon MX491 is common after many cleaning cycles. In most cases, a counter reset restores printing.

Ink absorber pads store waste ink during normal operation. Canon firmware tracks this using a software counter and may stop printing when it reaches the limit.

This page is prepared for Canon MX491. Service mode instructions are shown only when a matching series procedure is known.

Reset the Ink Absorber Counter

After service mode is enabled (if required), the waste ink counter can be reset using a supported reset procedure/software.

Before You Continue

Treat the reset as a maintenance step. If your printer has extremely high usage, consider cleaning/replacing absorber pads to avoid overflow.

Need a reset solution?

Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

For best results, avoid rushing button presses—consistent timing matters.

FAQ

Does every Canon model need service mode?

No. The generator shows service mode steps only when the series procedure is known.

Does reset clean the absorber pads?

No. It resets the counter (software). Pads may still require physical maintenance in high-usage cases.

How many times should I press Stop/Reset?

It depends on the series. Many use 5 presses; PRO/imagePROGRAF/MG use 6 in this generator.

How long does it take?

Usually a few minutes once the correct steps are followed.

Guide prepared for Canon MX491 – Ink Absorber / Waste Ink Counter Reset using Wic Reset Connect.