Canon MX478 Ink Absorber Reset Without Service Center

Canon MX478 Ink Absorber Full Reset

The “Ink Absorber Full” / service required message on Canon MX478 is common after many cleaning cycles. In most cases, a counter reset restores printing.

During head cleaning, surplus ink is routed to internal absorber pads. Canon MX478 monitors this via a counter and can lock printing at a threshold.

This page is prepared for Canon MX478. Service mode instructions are shown only when a matching series procedure is known.

Typical Signs

‘Ink Absorber Full’ / ‘Service Required’ message
Support/service code (varies by series)
Printing blocked after cleaning cycles
Reset required to continue printing

Perform the Waste Ink Counter Reset

Once the counter is cleared, Canon MX478 should exit the locked state and printing should resume normally.

Important Notes

Treat the reset as a maintenance step. If your printer has extremely high usage, consider cleaning/replacing absorber pads to avoid overflow.

Reset tools and instructions

Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

Use a reliable USB connection and follow the steps in order.

FAQ

How many times should I press Stop/Reset?

It depends on the series. Many use 5 presses; PRO/imagePROGRAF/MG use 6 in this generator.

Does every Canon model need service mode?

No. The generator shows service mode steps only when the series procedure is known.

How long does it take?

Usually a few minutes once the correct steps are followed.

Does reset clean the absorber pads?

No. It resets the counter (software). Pads may still require physical maintenance in high-usage cases.

Guide prepared for Canon MX478 – Ink Absorber / Waste Ink Counter Reset using Wic Reset Connect.