Canon MX370 Reset Ink Absorber – Complete Tutorial

Canon MX370 Ink Absorber Full Reset

Canon MX370 can lock printing when the waste ink (ink absorber) counter hits a predefined threshold. This guide explains how to reset it.

During head cleaning, surplus ink is routed to internal absorber pads. Canon MX370 monitors this via a counter and can lock printing at a threshold.

This page is prepared for Canon MX370. Service mode instructions are shown only when a matching series procedure is known.

Finalize the Reset and Restore Printing

Completing the reset clears the internal ink absorber counter stored in printer memory and restores normal operation.

Maintenance Reminder

If absorber pads are truly saturated, ignoring maintenance can lead to ink leakage inside the printer. The counter reset only removes the software lock.

Need a reset solution?

Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

If your model does not show a service mode section, it means no matching procedure was found for its series.

FAQ

How many times should I press Stop/Reset?

It depends on the series. Many use 5 presses; PRO/imagePROGRAF/MG use 6 in this generator.

Does reset clean the absorber pads?

No. It resets the counter (software). Pads may still require physical maintenance in high-usage cases.

Does every Canon model need service mode?

No. The generator shows service mode steps only when the series procedure is known.

How long does it take?

Usually a few minutes once the correct steps are followed.

Guide prepared for Canon MX370 – Ink Absorber / Waste Ink Counter Reset using Wic Reset Connect.