Canon MX357 Ink Absorber Reset Without Service Center

Canon MX357 Ink Absorber Full Reset

When Canon MX357 triggers an ink absorber full condition, the printer may block printing as a protective measure. The solution is typically a waste ink counter reset.

Inside Canon printers, absorber pads collect excess ink from cleaning and maintenance cycles. The printer uses an internal counter to estimate pad saturation.

This page is prepared for Canon MX357. Service mode instructions are shown only when a matching series procedure is known.

How the Error Appears

Service / maintenance warning on the screen or driver
Printer refuses to print even with ink available
Blinking lights and queued jobs fail
Error reappears after restart

Finalize the Reset and Restore Printing

Once the counter is cleared, Canon MX357 should exit the locked state and printing should resume normally.

Warnings

Treat the reset as a maintenance step. If your printer has extremely high usage, consider cleaning/replacing absorber pads to avoid overflow.

Download & get started

Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

For best results, avoid rushing button presses—consistent timing matters.

FAQ

Does reset clean the absorber pads?

No. It resets the counter (software). Pads may still require physical maintenance in high-usage cases.

How many times should I press Stop/Reset?

It depends on the series. Many use 5 presses; PRO/imagePROGRAF/MG use 6 in this generator.

Does every Canon model need service mode?

No. The generator shows service mode steps only when the series procedure is known.

How long does it take?

Usually a few minutes once the correct steps are followed.

Guide prepared for Canon MX357 – Ink Absorber / Waste Ink Counter Reset using Wic Reset Connect.