MP268 Waste Ink Counter Reset (Canon Printers)

Canon MP268 Ink Absorber Full Reset

Canon MP268 can lock printing when the waste ink (ink absorber) counter hits a predefined threshold. This guide explains how to reset it.

During head cleaning, surplus ink is routed to internal absorber pads. Canon MP268 monitors this via a counter and can lock printing at a threshold.

This page is prepared for Canon MP268. Service mode instructions are shown only when a matching series procedure is known.

Reset the Ink Absorber Counter

Once the counter is cleared, Canon MP268 should exit the locked state and printing should resume normally.

Important Notes

If absorber pads are truly saturated, ignoring maintenance can lead to ink leakage inside the printer. The counter reset only removes the software lock.

Reset tools and instructions

Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

If your model does not show a service mode section, it means no matching procedure was found for its series.

Common Fixes

Power-cycle the printer and try again.
Repeat the service mode steps carefully (timing matters).
Use the correct Stop/Reset press count for your series.
Close other Canon printer utilities while resetting.
Try a different USB cable/port if using PC software.

Frequently Asked Questions

Does reset clean the absorber pads?

No. It resets the counter (software). Pads may still require physical maintenance in high-usage cases.

How long does it take?

Usually a few minutes once the correct steps are followed.

How many times should I press Stop/Reset?

It depends on the series. Many use 5 presses; PRO/imagePROGRAF/MG use 6 in this generator.

Does every Canon model need service mode?

No. The generator shows service mode steps only when the series procedure is known.

Guide prepared for Canon MP268 – Ink Absorber / Waste Ink Counter Reset using Wic Reset Connect.