MP252 Printer Reset – Ink Absorber Counter Explained

Canon MP252 Ink Absorber Full Reset

If your Canon MP252 suddenly refuses to print and shows a maintenance or service warning, the ink absorber counter may have reached its limit.

Ink absorber pads store waste ink during normal operation. Canon firmware tracks this using a software counter and may stop printing when it reaches the limit.

This page is prepared for Canon MP252. Service mode instructions are shown only when a matching series procedure is known.

How the Error Appears

‘Ink Absorber Full’ / ‘Service Required’ message
Support/service code (varies by series)
Printing blocked after cleaning cycles
Reset required to continue printing

Reset the Ink Absorber Counter

Completing the reset clears the internal ink absorber counter stored in printer memory and restores normal operation.

Warnings

Resetting the counter does not physically clean the absorber pads. For heavy usage, pads may eventually need cleaning or replacement.

Reset tools and instructions

Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

Use a reliable USB connection and follow the steps in order.

Common Fixes

Repeat the service mode steps carefully (timing matters).
Power-cycle the printer and try again.
Use the correct Stop/Reset press count for your series.
Close other Canon printer utilities while resetting.
Try a different USB cable/port if using PC software.

FAQ

Does every Canon model need service mode?

No. The generator shows service mode steps only when the series procedure is known.

How long does it take?

Usually a few minutes once the correct steps are followed.

Does reset clean the absorber pads?

No. It resets the counter (software). Pads may still require physical maintenance in high-usage cases.

How many times should I press Stop/Reset?

It depends on the series. Many use 5 presses; PRO/imagePROGRAF/MG use 6 in this generator.

Guide prepared for Canon MP252 – Ink Absorber / Waste Ink Counter Reset using Wic Reset Connect.