Canon MG6350 Ink Absorber Full Reset

When Canon MG6350 triggers an ink absorber full condition, the printer may block printing as a protective measure. The solution is typically a waste ink counter reset.

Inside Canon printers, absorber pads collect excess ink from cleaning and maintenance cycles. The printer uses an internal counter to estimate pad saturation.

This page is prepared for Canon MG6350. Service mode instructions are shown only when a matching series procedure is known.

How to Enter Service Mode on Canon MG6350

Some Canon series require entering service mode before the ink absorber counter can be reset.

1. Turn the printer OFF.
2. Press and hold Stop/Reset.
3. While holding Stop/Reset, press and hold Power.
4. Release Stop/Reset (keep holding Power).
5. Press Stop/Reset 6 times.
6. Release Power — the printer should enter service mode.

If it doesn’t work, repeat the sequence carefully. The press count depends on the series.

Finalize the Reset and Restore Printing

After service mode is enabled (if required), the waste ink counter can be reset using a supported reset procedure/software.

Warnings

Resetting the counter does not physically clean the absorber pads. For heavy usage, pads may eventually need cleaning or replacement.

Reset tools and instructions

Use a reliable USB connection and follow the steps in order.

Common Fixes

• Close other Canon printer utilities while resetting.
• Repeat the service mode steps carefully (timing matters).
• Try a different USB cable/port if using PC software.
• Power-cycle the printer and try again.
• Use the correct Stop/Reset press count for your series.