Canon MB5455 Ink Absorber Full Reset

If your Canon MB5455 suddenly refuses to print and shows a maintenance or service warning, the ink absorber counter may have reached its limit.

Ink absorber pads store waste ink during normal operation. Canon firmware tracks this using a software counter and may stop printing when it reaches the limit.

This page is prepared for Canon MB5455. Service mode instructions are shown only when a matching series procedure is known.

Common Symptoms

• Service / maintenance warning on the screen or driver
• Printer refuses to print even with ink available
• Blinking lights and queued jobs fail
• Error reappears after restart

Perform the Waste Ink Counter Reset

Once the counter is cleared, Canon MB5455 should exit the locked state and printing should resume normally.

Warnings

Resetting the counter does not physically clean the absorber pads. For heavy usage, pads may eventually need cleaning or replacement.

Need a reset solution?

If your model does not show a service mode section, it means no matching procedure was found for its series.

Common Fixes

• Try a different USB cable/port if using PC software.
• Use the correct Stop/Reset press count for your series.
• Repeat the service mode steps carefully (timing matters).
• Power-cycle the printer and try again.
• Close other Canon printer utilities while resetting.

Frequently Asked Questions