Canon iP2772 Printer Ink Absorber Full – How to Reset

Canon iP2772 Ink Absorber Full Reset

The “Ink Absorber Full” / service required message on Canon iP2772 is common after many cleaning cycles. In most cases, a counter reset restores printing.

Inside Canon printers, absorber pads collect excess ink from cleaning and maintenance cycles. The printer uses an internal counter to estimate pad saturation.

This page is prepared for Canon iP2772. Service mode instructions are shown only when a matching series procedure is known.

Finalize the Reset and Restore Printing

After service mode is enabled (if required), the waste ink counter can be reset using a supported reset procedure/software.

Warnings

Resetting the counter does not physically clean the absorber pads. For heavy usage, pads may eventually need cleaning or replacement.

Need a reset solution?

Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

For best results, avoid rushing button presses—consistent timing matters.

Troubleshooting

Power-cycle the printer and try again.
Repeat the service mode steps carefully (timing matters).
Use the correct Stop/Reset press count for your series.
Close other Canon printer utilities while resetting.
Try a different USB cable/port if using PC software.

FAQ

How long does it take?

Usually a few minutes once the correct steps are followed.

Does reset clean the absorber pads?

No. It resets the counter (software). Pads may still require physical maintenance in high-usage cases.

Does every Canon model need service mode?

No. The generator shows service mode steps only when the series procedure is known.

How many times should I press Stop/Reset?

It depends on the series. Many use 5 presses; PRO/imagePROGRAF/MG use 6 in this generator.

Guide prepared for Canon iP2772 – Ink Absorber / Waste Ink Counter Reset using Wic Reset Connect.