Canon imagePROGRAF PRO-200 Ink Absorber Full Reset

The “Ink Absorber Full” / service required message on Canon imagePROGRAF PRO-200 is common after many cleaning cycles. In most cases, a counter reset restores printing.

During head cleaning, surplus ink is routed to internal absorber pads. Canon imagePROGRAF PRO-200 monitors this via a counter and can lock printing at a threshold.

This page is prepared for Canon imagePROGRAF PRO-200. Service mode instructions are shown only when a matching series procedure is known.

How the Error Appears

• ‘Ink Absorber Full’ / ‘Service Required’ message
• Support/service code (varies by series)
• Printing blocked after cleaning cycles
• Reset required to continue printing

How to Enter Service Mode on Canon imagePROGRAF PRO-200

If your Canon imagePROGRAF PRO-200 supports service mode reset, follow the steps below before performing the counter reset.

1. Turn the printer OFF.
2. Press and hold Stop/Reset.
3. While holding Stop/Reset, press and hold Power.
4. Release Stop/Reset (keep holding Power).
5. Press Stop/Reset 6 times.
6. Release Power — the printer should enter service mode.

If it doesn’t work, repeat the sequence carefully. The press count depends on the series.

Finalize the Reset and Restore Printing

After service mode is enabled (if required), the waste ink counter can be reset using a supported reset procedure/software.

Important Notes

If absorber pads are truly saturated, ignoring maintenance can lead to ink leakage inside the printer. The counter reset only removes the software lock.

Download & get started

For best results, avoid rushing button presses—consistent timing matters.