IB4150 Waste Ink Counter Reset (Canon Printers)

Canon IB4150 Ink Absorber Full Reset

The “Ink Absorber Full” / service required message on Canon IB4150 is common after many cleaning cycles. In most cases, a counter reset restores printing.

Ink absorber pads store waste ink during normal operation. Canon firmware tracks this using a software counter and may stop printing when it reaches the limit.

This page is prepared for Canon IB4150. Service mode instructions are shown only when a matching series procedure is known.

Typical Signs

‘Ink Absorber Full’ / ‘Service Required’ message
Support/service code (varies by series)
Printing blocked after cleaning cycles
Reset required to continue printing

Finalize the Reset and Restore Printing

Completing the reset clears the internal ink absorber counter stored in printer memory and restores normal operation.

Important Notes

Resetting the counter does not physically clean the absorber pads. For heavy usage, pads may eventually need cleaning or replacement.

Need a reset solution?

Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

If your model does not show a service mode section, it means no matching procedure was found for its series.

Frequently Asked Questions

Does reset clean the absorber pads?

No. It resets the counter (software). Pads may still require physical maintenance in high-usage cases.

How long does it take?

Usually a few minutes once the correct steps are followed.

Does every Canon model need service mode?

No. The generator shows service mode steps only when the series procedure is known.

How many times should I press Stop/Reset?

It depends on the series. Many use 5 presses; PRO/imagePROGRAF/MG use 6 in this generator.

Guide prepared for Canon IB4150 – Ink Absorber / Waste Ink Counter Reset using Wic Reset Connect.