Canon G6090 Ink Absorber Full Reset

Canon G6090 can lock printing when the waste ink (ink absorber) counter hits a predefined threshold. This guide explains how to reset it.

Ink absorber pads store waste ink during normal operation. Canon firmware tracks this using a software counter and may stop printing when it reaches the limit.

This page is prepared for Canon G6090. Service mode instructions are shown only when a matching series procedure is known.

Common Symptoms

• Service / maintenance warning on the screen or driver
• Printer refuses to print even with ink available
• Blinking lights and queued jobs fail
• Error reappears after restart

How to Enter Service Mode on Canon G6090

If your Canon G6090 supports service mode reset, follow the steps below before performing the counter reset.

1. Turn the printer OFF.
2. Press and hold Stop/Reset.
3. While holding Stop/Reset, press and hold Power.
4. Release Stop/Reset (keep holding Power).
5. Press Stop/Reset 5 times.
6. Release Power — the printer should enter service mode.

If it doesn’t work, repeat the sequence carefully. The press count depends on the series.

Clear the Ink Absorber / Waste Ink Counter

Completing the reset clears the internal ink absorber counter stored in printer memory and restores normal operation.

Important Notes

Resetting the counter does not physically clean the absorber pads. For heavy usage, pads may eventually need cleaning or replacement.

Download & get started

For best results, avoid rushing button presses—consistent timing matters.

Troubleshooting

• Power-cycle the printer and try again.
• Repeat the service mode steps carefully (timing matters).
• Try a different USB cable/port if using PC software.
• Use the correct Stop/Reset press count for your series.
• Close other Canon printer utilities while resetting.