Canon G3100 Ink Absorber Full Reset

When Canon G3100 triggers an ink absorber full condition, the printer may block printing as a protective measure. The solution is typically a waste ink counter reset.

During head cleaning, surplus ink is routed to internal absorber pads. Canon G3100 monitors this via a counter and can lock printing at a threshold.

This page is prepared for Canon G3100. Service mode instructions are shown only when a matching series procedure is known.

Common Symptoms

• Service / maintenance warning on the screen or driver
• Printer refuses to print even with ink available
• Blinking lights and queued jobs fail
• Error reappears after restart

How to Enter Service Mode on Canon G3100

If your Canon G3100 supports service mode reset, follow the steps below before performing the counter reset.

1. Turn the printer OFF.
2. Press and hold Stop/Reset.
3. While holding Stop/Reset, press and hold Power.
4. Release Stop/Reset (keep holding Power).
5. Press Stop/Reset 5 times.
6. Release Power — the printer should enter service mode.

If it doesn’t work, repeat the sequence carefully. The press count depends on the series.

Finalize the Reset and Restore Printing

After service mode is enabled (if required), the waste ink counter can be reset using a supported reset procedure/software.

Warnings

If absorber pads are truly saturated, ignoring maintenance can lead to ink leakage inside the printer. The counter reset only removes the software lock.

Need a reset solution?

For best results, avoid rushing button presses—consistent timing matters.

Frequently Asked Questions