Reset Canon E514 Waste Ink Counter Easily

Canon E514 Ink Absorber Full Reset

Canon E514 can lock printing when the waste ink (ink absorber) counter hits a predefined threshold. This guide explains how to reset it.

During head cleaning, surplus ink is routed to internal absorber pads. Canon E514 monitors this via a counter and can lock printing at a threshold.

This page is prepared for Canon E514. Service mode instructions are shown only when a matching series procedure is known.

Typical Signs

‘Ink Absorber Full’ / ‘Service Required’ message
Support/service code (varies by series)
Printing blocked after cleaning cycles
Reset required to continue printing

Perform the Waste Ink Counter Reset

Once the counter is cleared, Canon E514 should exit the locked state and printing should resume normally.

Important Notes

If absorber pads are truly saturated, ignoring maintenance can lead to ink leakage inside the printer. The counter reset only removes the software lock.

Reset tools and instructions

Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

For best results, avoid rushing button presses—consistent timing matters.

Troubleshooting

Close other Canon printer utilities while resetting.
Use the correct Stop/Reset press count for your series.
Power-cycle the printer and try again.
Try a different USB cable/port if using PC software.
Repeat the service mode steps carefully (timing matters).

FAQ

How many times should I press Stop/Reset?

It depends on the series. Many use 5 presses; PRO/imagePROGRAF/MG use 6 in this generator.

Does every Canon model need service mode?

No. The generator shows service mode steps only when the series procedure is known.

Does reset clean the absorber pads?

No. It resets the counter (software). Pads may still require physical maintenance in high-usage cases.

How long does it take?

Usually a few minutes once the correct steps are followed.

Guide prepared for Canon E514 – Ink Absorber / Waste Ink Counter Reset using Wic Reset Connect.