Epson ET-2815 Waste Ink Counter Reset

The Epson ET-2815 delivers reliable printing, but periodic maintenance routines can increase the waste ink counter and eventually trigger a ‘Service Required’ lock.

The Epson ET-2815 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Understanding the Epson ET-2815 Waste Ink Counter

Most Epson ET-2815 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

Typical Signs

• Printer refuses to print even with ink available
• Epson Status Monitor shows maintenance warning
• Blinking lights and blocked jobs
• Device is locked until reset is performed

Reset Epson ET-2815 Waste Ink Counter in 3 Steps

1. Stap 1: Prepare a Windows PC + USB cable and connect Epson ET-2815 directly. Keep Internet enabled for validation.
2. Stap 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson ET-2815.
3. Stap 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson ET-2815.

Most Epson ET-2815 waste counter resets finish in ~1–2 minutes.

System Requirements

• USB connection required (Wi-Fi reset not supported)
• Windows 7/8/10/11 PC
• Stable Internet connection during reset
• Valid Wic Reset Connect reset key

Troubleshooting

• Restart printer and PC, then try again.
• Close Epson Status Monitor or other printer utilities.
• Temporarily disable VPN/proxy if validation fails.
• Use a direct USB connection (avoid hubs).
• Run the app as Administrator.

Frequently Asked Questions