Fix Epson TX110 Service Required – Waste Counter Reset

Epson TX110 Waste Ink Counter Reset

If your Epson TX110 suddenly refuses to print and shows a maintenance warning, it is often caused by the waste ink (ink pad) counter threshold.

The Epson TX110 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Understanding the Epson TX110 Waste Ink Counter

With Wic Reset Connect, you can reset the Epson TX110 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Typical Signs

  • ‘Service Required’ / service life message in driver or utility
  • Maintenance/support code (varies by model/driver)
  • Printing stops after cleaning cycles
  • Warning repeats after restarting the printer

Step-by-Step: Epson TX110 Waste Counter Reset

  1. Step 1: Connect Epson TX110 to a Windows computer with a stable Internet connection using a USB cable.
  2. Step 2: Run Wic Reset Connect as Administrator and confirm Epson TX110 is detected.
  3. Step 3: Use the key to reset the counter, wait for completion, then restart Epson TX110 to finalize.
Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

Most Epson TX110 waste counter resets finish in ~1–2 minutes.

System Requirements

  • USB connection required (Wi-Fi reset not supported)
  • Windows 7/8/10/11 PC
  • Stable Internet connection during reset
  • Valid Wic Reset Connect reset key

FAQ

Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
How long does it take?
Usually about 1–2 minutes.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.

Guide prepared for Epson TX110 – Waste Ink Counter Reset using Wic Reset Connect.

Shopping Cart