Epson R270 Waste Ink Counter Reset
The Epson R270 delivers reliable printing, but periodic maintenance routines can increase the waste ink counter and eventually trigger a ‘Service Required’ lock.
A waste ink counter in the Epson R270 accumulates after cleaning operations. Once it reaches a limit, printing is stopped to prevent overflow.
What Causes the Epson R270 Ink Pad Counter Warning?
With Wic Reset Connect, you can reset the Epson R270 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.
Typical Signs
- Printer refuses to print even with ink available
- Epson Status Monitor shows maintenance warning
- Blinking lights and blocked jobs
- Device is locked until reset is performed
Three Steps to Restore Epson R270 Printing
- Step 1: Prepare a Windows PC + USB cable and connect Epson R270 directly. Keep Internet enabled for validation.
- Step 2: Run Wic Reset Connect as Administrator and confirm Epson R270 is detected.
- Step 3: Paste the reset key, click Reset, and after completion power-cycle Epson R270.
Most Epson R270 waste counter resets finish in ~1–2 minutes.
System Requirements
- Windows 7/8/10/11 PC
- Valid Wic Reset Connect reset key
- Stable Internet connection during reset
- USB connection required (Wi-Fi reset not supported)
Troubleshooting
- Use a direct USB connection (avoid hubs).
- Try another USB cable (some cables are charge-only).
- Temporarily disable VPN/proxy if validation fails.
- Close Epson Status Monitor or other printer utilities.
- Run the app as Administrator.
FAQ
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
How long does it take?
Usually about 1–2 minutes.
Guide prepared for Epson R270 – Waste Ink Counter Reset using Wic Reset Connect.