Reset Epson L5198 Waste Ink Counter in Minutes

Epson L5198 Waste Ink Counter Reset

When the Epson L5198 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson L5198 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Why the Epson L5198 Stops Printing (Waste Counter Limit)

Most Epson L5198 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

How the Error Appears

  • ‘Service Required’ / service life message in driver or utility
  • Maintenance/support code (varies by model/driver)
  • Printing stops after cleaning cycles
  • Warning repeats after restarting the printer

Epson L5198 Ink Pad Counter Reset – Quick Steps

  1. Fase 1: Prepare a Windows PC + USB cable and connect Epson L5198 directly. Keep Internet enabled for validation.
  2. Fase 2: Start Wic Reset Connect in Administrator mode and wait until Epson L5198 appears in the device list.
  3. Fase 3: Use the key to reset the counter, wait for completion, then restart Epson L5198 to finalize.
Buy Reset Key ⬇️ Download Wic Reset Connect Istruzioni

Most Epson L5198 waste counter resets finish in ~1–2 minutes.

FAQ

How long does it take?
Usually about 1–2 minutes.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.

Guide prepared for Epson L5198 – Waste Ink Counter Reset using Wic Reset Connect.

Carrello della spesa