Epson DX8450 Waste Ink Counter Reset

When the Epson DX8450 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

The Epson DX8450 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

What Causes the Epson DX8450 Ink Pad Counter Warning?

Most Epson DX8450 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

How the Error Appears

• Printer refuses to print even with ink available
• Epson Status Monitor shows maintenance warning
• Blinking lights and blocked jobs
• Device is locked until reset is performed

Step-by-Step: Epson DX8450 Waste Counter Reset

1. Step 1: Connect Epson DX8450 to a Windows computer with a stable Internet connection using a USB cable.
2. Step 2: Start Wic Reset Connect in Administrator mode and wait until Epson DX8450 appears in the device list.
3. Step 3: Use the key to reset the counter, wait for completion, then restart Epson DX8450 to finalize.

Most Epson DX8450 waste counter resets finish in ~1–2 minutes.

Before You Begin

• Valid Wic Reset Connect reset key
• Stable Internet connection during reset
• Windows 7/8/10/11 PC
• USB connection required (Wi-Fi reset not supported)

Common Fixes

• Run the app as Administrator.
• Use a direct USB connection (avoid hubs).
• Restart printer and PC, then try again.
• Try another USB cable (some cables are charge-only).
• Temporarily disable VPN/proxy if validation fails.

Frequently Asked Questions