Model-specific reset guide
Canon TS8052 Ink Absorber Full Reset
Canon TS8052 may block print jobs after recording enough cleaning and maintenance cycles. Use the sequence below to enter service mode and reset the stored value.
What the Canon TS8052 service message means
Waste ink is routed away from the print head and retained inside the printer. The firmware in Canon TS8052 calculates usage and may stop new jobs to reduce overflow risk.
Wic Reset Connect is designed to reset the compatible counter in Canon TS8052. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon TS8052
- Turn the printer off.
- Tekan dan tahan Berhenti/Reset.
- Sambil menahan Stop/Reset, tekan dan tahan Daya.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 5 kali.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon TS8052
Prepare Canon TS8052 before entering the key. A stable service-mode state and direct USB connection are essential.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon TS8052 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon TS8052 is not detected
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
- Close Canon maintenance utilities and clear paused print jobs before opening Wic Reset Connect.
Canon TS8052 reset FAQ
Does the reset clean the ink absorber?
No. It resets the stored counter. Inspect, clean or replace the absorber pads when their physical condition requires maintenance.
Berapa kali saya harus menekan Stop/Reset?
For Canon TS8052, use 5 Stop/Reset presses in the sequence shown on this page.
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
Restore Canon TS8052
Prepare Canon TS8052, enter service mode and complete the reset with a valid Wic Reset Connect key.