Model-specific reset guide
Canon TS5180 Ink Absorber Full Reset
An absorber warning on Canon TS5180 does not necessarily mean that the printer is mechanically damaged. The software counter and the physical pads must be considered separately.
What stops Canon TS5180 from printing
An absorber message concerns both software and maintenance. The counter can be reset, while heavily saturated pads may still need cleaning or replacement.
Wic Reset Connect is designed to reset the compatible counter in Canon TS5180. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon TS5180
- Turn the printer off.
- Tekan dan tahan Berhenti/Reset.
- Sambil menahan Stop/Reset, tekan dan tahan Daya.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 5 kali.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon TS5180
First make sure the power indicator is steady and no cartridge or mechanical error is active. Then prepare the Windows computer and direct USB connection.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon TS5180 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon TS5180 is not detected
- Connect Canon TS5180 directly to the computer and try another data-capable USB cable or port.
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
Canon TS5180 reset FAQ
Berapa kali saya harus menekan Stop/Reset?
For Canon TS5180, use 5 Stop/Reset presses in the sequence shown on this page.
Does Canon TS5180 require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
Restore Canon TS5180
Ready to reset Canon TS5180? Verify the power light, USB connection and service-mode state before continuing.