Model-specific reset guide
Canon MG3680 Ink Absorber Full Reset
Canon MG3680 may block print jobs after recording enough cleaning and maintenance cycles. Use the sequence below to enter service mode and reset the stored value.
Why Canon MG3680 reports an absorber error
An absorber message concerns both software and maintenance. The counter can be reset, while heavily saturated pads may still need cleaning or replacement.
Wic Reset Connect is designed to reset the compatible counter in Canon MG3680. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon MG3680
- Turn the printer off.
- Tekan dan tahan Berhenti/Reset.
- Sambil menahan Stop/Reset, tekan dan tahan Daya.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 6 kali.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon MG3680
Check cartridges, close Canon utilities and connect the printer directly to Windows before beginning the reset.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon MG3680 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon MG3680 is not detected
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- Connect Canon MG3680 directly to the computer and try another data-capable USB cable or port.
Canon MG3680 reset FAQ
Berapa kali saya harus menekan Stop/Reset?
For Canon MG3680, use 6 Stop/Reset presses in the sequence shown on this page.
Does the reset clean the ink absorber?
No. It resets the stored counter. Inspect, clean or replace the absorber pads when their physical condition requires maintenance.
Does Canon MG3680 require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
Restore Canon MG3680
Follow the verified steps for Canon MG3680, then restart the printer and return to normal operation.