Model-specific reset guide
Canon GM4040 Ink Absorber Full Reset
Canon GM4040 may block print jobs after recording enough cleaning and maintenance cycles. Use the sequence below to enter service mode and reset the stored value.
Why Canon GM4040 reports an absorber error
The absorber pads collect ink generated during print-head cleaning. Canon GM4040 tracks those maintenance cycles in memory rather than measuring the pads directly.
Wic Reset Connect is designed to reset the compatible counter in Canon GM4040. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon GM4040
- Turn the printer off.
- Tekan dan tahan Berhenti/Reset.
- Sambil menahan Stop/Reset, tekan dan tahan Daya.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 5 kali.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon GM4040
First make sure the power indicator is steady and no cartridge or mechanical error is active. Then prepare the Windows computer and direct USB connection.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon GM4040 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon GM4040 is not detected
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- Connect Canon GM4040 directly to the computer and try another data-capable USB cable or port.
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
Canon GM4040 reset FAQ
Does the reset clean the ink absorber?
No. It resets the stored counter. Inspect, clean or replace the absorber pads when their physical condition requires maintenance.
Can I perform the reset over Wi-Fi?
No. Use a direct USB connection between the printer and a Windows computer.
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
Restore Canon GM4040
Follow the verified steps for Canon GM4040, then restart the printer and return to normal operation.