How to Reset Epson TX100 Waste Ink Counter

Epson TX100 Waste Ink Counter Reset

When the Epson TX100 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson TX100 uses a software counter to estimate pad saturation and locks printing at a set threshold.

What Causes the Epson TX100 Ink Pad Counter Warning?

Most Epson TX100 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

How the Error Appears

  • ‘Service Required’ / service life message in driver or utility
  • Maintenance/support code (varies by model/driver)
  • Printing stops after cleaning cycles
  • Warning repeats after restarting the printer

Three Steps to Restore Epson TX100 Printing

  1. 1. lépés: Connect Epson TX100 to a Windows computer with a stable Internet connection using a USB cable.
  2. 2. lépés: Open Wic Reset Connect with admin privileges and verify device recognition for Epson TX100.
  3. 3. lépés: Paste the reset key, click Reset, and after completion power-cycle Epson TX100.
Buy Reset Key ⬇️ Download Wic Reset Connect Utasítás

Most Epson TX100 waste counter resets finish in ~1–2 minutes.

System Requirements

  • Windows 7/8/10/11 PC
  • USB connection required (Wi-Fi reset not supported)
  • Stable Internet connection during reset
  • Valid Wic Reset Connect reset key

Frequently Asked Questions

How long does it take?
Usually about 1–2 minutes.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.

Guide prepared for Epson TX100 – Waste Ink Counter Reset using Wic Reset Connect.

Bevásárlókocsi