Epson ME-520 Waste Ink Counter Reset

When the Epson ME-520 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson ME-520 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Why Does the Epson ME-520 Show ‘Service Required’?

With Wic Reset Connect, you can reset the Epson ME-520 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Common Symptoms

• Printer refuses to print even with ink available
• Epson Status Monitor shows maintenance warning
• Blinking lights and blocked jobs
• Device is locked until reset is performed

Epson ME-520 Ink Pad Counter Reset – Quick Steps

1. 1. lépés: Connect Epson ME-520 to a Windows computer with a stable Internet connection using a USB cable.
2. 2. lépés: Start Wic Reset Connect in Administrator mode and wait until Epson ME-520 appears in the device list.
3. 3. lépés: Paste the reset key, click Reset, and after completion power-cycle Epson ME-520.

Most Epson ME-520 waste counter resets finish in ~1–2 minutes.

What You Need

• Windows 7/8/10/11 PC
• Valid Wic Reset Connect reset key
• Stable Internet connection during reset
• USB connection required (Wi-Fi reset not supported)

Troubleshooting

• Close Epson Status Monitor or other printer utilities.
• Restart printer and PC, then try again.
• Temporarily disable VPN/proxy if validation fails.
• Run the app as Administrator.
• Use a direct USB connection (avoid hubs).

Frequently Asked Questions