Epson XP-442 Waste Ink Counter Reset

When the Epson XP-442 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson XP-442 uses a software counter to estimate pad saturation and locks printing at a set threshold.

What Causes the Epson XP-442 Ink Pad Counter Warning?

Posjet servisu je često nepotrebno. Wic Reset Connect allows a safe Epson XP-442 waste counter reset in minutes.

Kako se pogreška prikazuje

• Pisač odbija ispisati čak i kad je tinte dovoljno.
• Epson Status Monitor prikazuje upozorenje na održavanje
• Treptajuća svjetla i blokirani poslovi
• Uređaj je zaključan dok se ne izvrši resetiranje.

Epson XP-442 Ink Pad Counter Reset – Quick Steps

1. Korak 1: Prepare a Windows PC + USB cable and connect Epson XP-442 directly. Keep Internet enabled for validation.
2. Korak 2: Otvoreno Wic Reset Connect with admin privileges and verify device recognition for Epson XP-442.
3. Korak 3: Use the key to reset the counter, wait for completion, then restart Epson XP-442 to finalize.

Most Epson XP-442 waste counter resets finish in ~1–2 minutes.

Uobičajena rješenja

• Ponovno pokrenite pisač i računalo, zatim pokušajte ponovno.
• Isprobajte drugi USB kabel (neki kabeli služe samo za punjenje).
• Privremeno onemogućite VPN/proxy ako provjera ne uspije.
• Pokrenite aplikaciju kao administrator.
• Koristite izravno USB-povezivanje (izbjegavajte USB-hubove).

Često postavljana pitanja