Model-specific reset guide
Canon TS5060 Ink Absorber Full Reset
The waste ink system in Canon TS5060 collects ink used during cleaning cycles. Once the estimated limit is reached, service mode and a compatible counter reset may be required.
What stops Canon TS5060 from printing
An absorber message concerns both software and maintenance. The counter can be reset, while heavily saturated pads may still need cleaning or replacement.
Wic Reset Connect is designed to reset the compatible counter in Canon TS5060. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon TS5060
- Turn the printer off.
- Pritisnite i držite Zaustavi/Ponovno pokreni.
- Dok držite tipku Stop/Reset, pritisnite i držite Moć.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 5 puta.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon TS5060
Check cartridges, close Canon utilities and connect the printer directly to Windows before beginning the reset.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon TS5060 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon TS5060 is not detected
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
Canon TS5060 reset FAQ
Does the reset clean the ink absorber?
No. It resets the stored counter. Inspect, clean or replace the absorber pads when their physical condition requires maintenance.
Does Canon TS5060 require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
Koliko puta trebam pritisnuti Stop/Reset?
For Canon TS5060, use 5 Stop/Reset presses in the sequence shown on this page.
Restore Canon TS5060
Complete the Canon TS5060 absorber counter reset in a few carefully prepared steps.