Model-specific reset guide
Canon TR5010 Ink Absorber Full Reset
When Canon TR5010 reports that the ink absorber is full, turning it off and on will not normally remove the lock. The printer must be prepared correctly and its counter reset.
What the Canon TR5010 service message means
Cleaning operations send unused ink into absorber pads inside the printer. Canon TR5010 estimates their usage with an electronic counter and can lock printing when that value reaches its limit.
Wic Reset Connect is designed to reset the compatible counter in Canon TR5010. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon TR5010
- Turn the printer off.
- Pritisnite i držite Zaustavi/Ponovno pokreni.
- Dok držite tipku Stop/Reset, pritisnite i držite Moć.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 5 puta.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon TR5010
First make sure the power indicator is steady and no cartridge or mechanical error is active. Then prepare the Windows computer and direct USB connection.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon TR5010 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon TR5010 is not detected
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
Canon TR5010 reset FAQ
Does the reset clean the ink absorber?
No. It resets the stored counter. Inspect, clean or replace the absorber pads when their physical condition requires maintenance.
Koliko puta trebam pritisnuti Stop/Reset?
For Canon TR5010, use 5 Stop/Reset presses in the sequence shown on this page.
Does Canon TR5010 require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
Restore Canon TR5010
Use the correct sequence for Canon TR5010 and restore printing without an unnecessary service visit.