Model-specific reset guide
Canon PRO-10 Ink Absorber Full Reset
If Canon PRO-10 displays an ink absorber full or service-required warning, the stored waste ink counter may have reached its limit. This guide covers service mode, USB preparation and the reset itself.
Understanding the Canon PRO-10 ink absorber warning
Canon PRO-10 uses a stored counter as a maintenance safeguard. Reaching the threshold can produce an Ink Absorber Full, Service Required or related support-code message.
Wic Reset Connect is designed to reset the compatible counter in Canon PRO-10. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon PRO-10
- Turn the printer off.
- Pritisnite i držite Zaustavi/Ponovno pokreni.
- Dok držite tipku Stop/Reset, pritisnite i držite Moć.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset šest puta.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon PRO-10
The counter reset normally takes only a few minutes after Canon PRO-10 has entered service mode successfully.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon PRO-10 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon PRO-10 is not detected
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- Close Canon maintenance utilities and clear paused print jobs before opening Wic Reset Connect.
Canon PRO-10 reset FAQ
Does the reset clean the ink absorber?
No. It resets the stored counter. Inspect, clean or replace the absorber pads when their physical condition requires maintenance.
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
Can I perform the reset over Wi-Fi?
No. Use a direct USB connection between the printer and a Windows computer.
Restore Canon PRO-10
Follow the verified steps for Canon PRO-10, then restart the printer and return to normal operation.