Model-specific reset guide
Canon MX710 Ink Absorber Full Reset
An absorber warning on Canon MX710 does not necessarily mean that the printer is mechanically damaged. The software counter and the physical pads must be considered separately.
Why Canon MX710 reports an absorber error
The absorber pads collect ink generated during print-head cleaning. Canon MX710 tracks those maintenance cycles in memory rather than measuring the pads directly.
Wic Reset Connect is designed to reset the compatible counter in Canon MX710. The physical waste ink system should still be inspected and maintained when necessary.
Enter service mode on Canon MX710
The Stop/Reset press count varies across Canon series. Use the complete service-mode guide and select the procedure for this printer instead of guessing.
Reset the counter in Canon MX710
Work through the sequence without rushing. Incorrect button timing or a blinking power light means the printer is not ready for the counter reset.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the linked guide.
-
Connect directly by USB
Connect Canon MX710 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon MX710 is not detected
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
- Connect Canon MX710 directly to the computer and try another data-capable USB cable or port.
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
Canon MX710 reset FAQ
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
Does the reset clean the ink absorber?
No. It resets the stored counter. Inspect, clean or replace the absorber pads when their physical condition requires maintenance.
Koliko puta trebam pritisnuti Stop/Reset?
The correct count depends on the printer series. Use the linked Canon service-mode guide and do not guess.
Restore Canon MX710
Complete the Canon MX710 absorber counter reset in a few carefully prepared steps.