Model-specific reset guide
Canon MP980 Ink Absorber Full Reset
When Canon MP980 reports that the ink absorber is full, turning it off and on will not normally remove the lock. The printer must be prepared correctly and its counter reset.
Why Canon MP980 reports an absorber error
Waste ink is routed away from the print head and retained inside the printer. The firmware in Canon MP980 calculates usage and may stop new jobs to reduce overflow risk.
Wic Reset Connect is designed to reset the compatible counter in Canon MP980. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon MP980
- Turn the printer off.
- Pritisnite i držite Zaustavi/Ponovno pokreni.
- Dok držite tipku Stop/Reset, pritisnite i držite Moć.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 2 times.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon MP980
First make sure the power indicator is steady and no cartridge or mechanical error is active. Then prepare the Windows computer and direct USB connection.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon MP980 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon MP980 is not detected
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
- Close Canon maintenance utilities and clear paused print jobs before opening Wic Reset Connect.
- Connect Canon MP980 directly to the computer and try another data-capable USB cable or port.
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
Canon MP980 reset FAQ
Koliko puta trebam pritisnuti Stop/Reset?
For Canon MP980, use 2 Stop/Reset presses in the sequence shown on this page.
Does the reset clean the ink absorber?
No. It resets the stored counter. Inspect, clean or replace the absorber pads when their physical condition requires maintenance.
Does Canon MP980 require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
Restore Canon MP980
Ready to reset Canon MP980? Verify the power light, USB connection and service-mode state before continuing.