Model-specific reset guide
Canon G7060 Ink Absorber Full Reset
When Canon G7060 reports that the ink absorber is full, turning it off and on will not normally remove the lock. The printer must be prepared correctly and its counter reset.
What the Canon G7060 service message means
Waste ink is routed away from the print head and retained inside the printer. The firmware in Canon G7060 calculates usage and may stop new jobs to reduce overflow risk.
Wic Reset Connect is designed to reset the compatible counter in Canon G7060. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon G7060
- Turn the printer off.
- Pritisnite i držite Zaustavi/Ponovno pokreni.
- Dok držite tipku Stop/Reset, pritisnite i držite Moć.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 5 puta.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon G7060
Service mode must be entered correctly before Wic Reset Connect can communicate with the maintenance interface. Resolve other printer errors first.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon G7060 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon G7060 is not detected
- Connect Canon G7060 directly to the computer and try another data-capable USB cable or port.
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
Canon G7060 reset FAQ
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
Does the reset clean the ink absorber?
No. It resets the stored counter. Inspect, clean or replace the absorber pads when their physical condition requires maintenance.
Koliko puta trebam pritisnuti Stop/Reset?
For Canon G7060, use 5 Stop/Reset presses in the sequence shown on this page.
Restore Canon G7060
Complete the Canon G7060 absorber counter reset in a few carefully prepared steps.