Epson XP-430 Waste Ink Counter Reset
If your Epson XP-430 suddenly refuses to print and shows a maintenance warning, it is often caused by the waste ink (ink pad) counter threshold.
The Epson XP-430 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.
What Causes the Epson XP-430 Ink Pad Counter Warning?
With Wic Reset Connect, you can reset the Epson XP-430 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.
How the Error Appears
- Printer refuses to print even with ink available
- Epson Status Monitor shows maintenance warning
- Blinking lights and blocked jobs
- Device is locked until reset is performed
Reset Epson XP-430 Waste Ink Counter in 3 Steps
- Étape 1 : Connect Epson XP-430 to a Windows computer with a stable Internet connection using a USB cable.
- Étape 2 : Start Wic Reset Connect in Administrator mode and wait until Epson XP-430 appears in the device list.
- Étape 3 : Use the key to reset the counter, wait for completion, then restart Epson XP-430 to finalize.
Most Epson XP-430 waste counter resets finish in ~1–2 minutes.
Before You Begin
- USB connection required (Wi-Fi reset not supported)
- Valid Wic Reset Connect reset key
- Windows 7/8/10/11 PC
- Stable Internet connection during reset
Troubleshooting
- Restart printer and PC, then try again.
- Run the app as Administrator.
- Close Epson Status Monitor or other printer utilities.
- Use a direct USB connection (avoid hubs).
- Try another USB cable (some cables are charge-only).
FAQ
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
How long does it take?
Usually about 1–2 minutes.
Guide prepared for Epson XP-430 – Waste Ink Counter Reset using Wic Reset Connect.