How to Reset Epson XP-320 Waste Ink Counter

Epson XP-320 Waste Ink Counter Reset

When the Epson XP-320 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson XP-320 uses a software counter to estimate pad saturation and locks printing at a set threshold.

What Causes the Epson XP-320 Ink Pad Counter Warning?

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson XP-320 waste counter reset in minutes.

Step-by-Step: Epson XP-320 Waste Counter Reset

  1. Étape 1 : Prepare a Windows PC + USB cable and connect Epson XP-320 directly. Keep Internet enabled for validation.
  2. Étape 2 : Open Wic Reset Connect with admin privileges and verify device recognition for Epson XP-320.
  3. Étape 3 : Paste the reset key, click Reset, and after completion power-cycle Epson XP-320.
Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

Most Epson XP-320 waste counter resets finish in ~1–2 minutes.

What You Need

  • Windows 7/8/10/11 PC
  • Valid Wic Reset Connect reset key
  • Stable Internet connection during reset
  • USB connection required (Wi-Fi reset not supported)

Common Fixes

  • Temporarily disable VPN/proxy if validation fails.
  • Try another USB cable (some cables are charge-only).
  • Run the app as Administrator.
  • Close Epson Status Monitor or other printer utilities.
  • Use a direct USB connection (avoid hubs).

FAQ

How long does it take?
Usually about 1–2 minutes.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.

Guide prepared for Epson XP-320 – Waste Ink Counter Reset using Wic Reset Connect.

Panier