Epson NX219 Ink Pad Counter Reset Guide

Epson NX219 Waste Ink Counter Reset

When the Epson NX219 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson NX219 uses a software counter to estimate pad saturation and locks printing at a set threshold.

What Causes the Epson NX219 Ink Pad Counter Warning?

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson NX219 waste counter reset in minutes.

Reset Epson NX219 Waste Ink Counter in 3 Steps

  1. Étape 1 : Connect Epson NX219 to a Windows computer with a stable Internet connection using a USB cable.
  2. Étape 2 : Start Wic Reset Connect in Administrator mode and wait until Epson NX219 appears in the device list.
  3. Étape 3 : Use the key to reset the counter, wait for completion, then restart Epson NX219 to finalize.
Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

Most Epson NX219 waste counter resets finish in ~1–2 minutes.

Common Fixes

  • Temporarily disable VPN/proxy if validation fails.
  • Restart printer and PC, then try again.
  • Run the app as Administrator.
  • Try another USB cable (some cables are charge-only).
  • Use a direct USB connection (avoid hubs).

FAQ

Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
How long does it take?
Usually about 1–2 minutes.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.

Guide prepared for Epson NX219 – Waste Ink Counter Reset using Wic Reset Connect.

Panier