How to Reset Epson ET-2804 Waste Ink Counter

Epson ET-2804 Waste Ink Counter Reset

The Epson ET-2804 is a widely used Epson printer. Like many Epson devices, it can stop printing when the internal waste ink counter reaches its predefined limit.

The Epson ET-2804 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Understanding the Epson ET-2804 Waste Ink Counter

With Wic Reset Connect, you can reset the Epson ET-2804 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Three Steps to Restore Epson ET-2804 Printing

  1. Étape 1 : Connect Epson ET-2804 to a Windows computer with a stable Internet connection using a USB cable.
  2. Étape 2 : Open Wic Reset Connect with admin privileges and verify device recognition for Epson ET-2804.
  3. Étape 3 : Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson ET-2804.
Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

Most Epson ET-2804 waste counter resets finish in ~1–2 minutes.

Before You Begin

  • Windows 7/8/10/11 PC
  • Stable Internet connection during reset
  • USB connection required (Wi-Fi reset not supported)
  • Valid Wic Reset Connect reset key

Troubleshooting

  • Use a direct USB connection (avoid hubs).
  • Close Epson Status Monitor or other printer utilities.
  • Restart printer and PC, then try again.
  • Temporarily disable VPN/proxy if validation fails.
  • Run the app as Administrator.

FAQ

Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
How long does it take?
Usually about 1–2 minutes.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.

Guide prepared for Epson ET-2804 – Waste Ink Counter Reset using Wic Reset Connect.

Panier