Epson NX130 Waste Ink Counter Reset

When the Epson NX130 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson NX130 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Why Does the Epson NX130 Show ‘Service Required’?

Most Epson NX130 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

Common Symptoms

• ‘Service Required’ / service life message in driver or utility
• Maintenance/support code (varies by model/driver)
• Printing stops after cleaning cycles
• Warning repeats after restarting the printer

Step-by-Step: Epson NX130 Waste Counter Reset

1. Paso 1: Use a Windows PC (7–11) with Internet access. Connect Epson NX130 via USB (Wi-Fi reset is not supported).
2. Paso 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson NX130.
3. Paso 3: Paste the reset key, click Reset, and after completion power-cycle Epson NX130.

Most Epson NX130 waste counter resets finish in ~1–2 minutes.

Before You Begin

• Windows 7/8/10/11 PC
• USB connection required (Wi-Fi reset not supported)
• Stable Internet connection during reset
• Valid Wic Reset Connect reset key

Common Fixes

• Restart printer and PC, then try again.
• Temporarily disable VPN/proxy if validation fails.
• Try another USB cable (some cables are charge-only).
• Close Epson Status Monitor or other printer utilities.
• Run the app as Administrator.