Epson XP-344 Waste Ink Counter Reset

The Epson XP-344 delivers reliable printing, but periodic maintenance routines can increase the waste ink counter and eventually trigger a ‘Service Required’ lock.

The Epson XP-344 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

What Causes the Epson XP-344 Ink Pad Counter Warning?

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson XP-344 waste counter reset in minutes.

Epson XP-344 Ink Pad Counter Reset – Quick Steps

Step 1: Prepare a Windows PC + USB cable and connect Epson XP-344 directly. Keep Internet enabled for validation.
Step 2: Start Wic Reset Connect in Administrator mode and wait until Epson XP-344 appears in the device list.
Step 3: Paste the reset key, click Reset, and after completion power-cycle Epson XP-344.

Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

Most Epson XP-344 waste counter resets finish in ~1–2 minutes.

Before You Begin

USB connection required (Wi-Fi reset not supported)
Valid Wic Reset Connect reset key
Windows 7/8/10/11 PC
Stable Internet connection during reset

Common Fixes

Use a direct USB connection (avoid hubs).
Try another USB cable (some cables are charge-only).
Close Epson Status Monitor or other printer utilities.
Temporarily disable VPN/proxy if validation fails.
Restart printer and PC, then try again.

Frequently Asked Questions

Can I reset over Wi-Fi?

No. The reset requires a USB connection to a Windows PC.

What if reset doesn’t work?

Check USB cable/port, run as admin, and close other printer utilities.

How long does it take?

Usually about 1–2 minutes.

Do I need a service center?

Typically not for a waste ink counter lock; a reset is usually sufficient.

Guide prepared for Epson XP-344 – Waste Ink Counter Reset using Wic Reset Connect.