Epson ME-10 Waste Ink Counter Reset

If your Epson ME-10 suddenly refuses to print and shows a maintenance warning, it is often caused by the waste ink (ink pad) counter threshold.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson ME-10 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Why the Epson ME-10 Stops Printing (Waste Counter Limit)

With Wic Reset Connect, you can reset the Epson ME-10 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Typical Signs

• ‘Service Required’ / service life message in driver or utility
• Maintenance/support code (varies by model/driver)
• Printing stops after cleaning cycles
• Warning repeats after restarting the printer

Reset Epson ME-10 Waste Ink Counter in 3 Steps

1. Step 1: Prepare a Windows PC + USB cable and connect Epson ME-10 directly. Keep Internet enabled for validation.
2. Step 2: Run Wic Reset Connect as Administrator and confirm Epson ME-10 is detected.
3. Step 3: Use the key to reset the counter, wait for completion, then restart Epson ME-10 to finalize.

Most Epson ME-10 waste counter resets finish in ~1–2 minutes.

Before You Begin

• USB connection required (Wi-Fi reset not supported)
• Stable Internet connection during reset
• Windows 7/8/10/11 PC
• Valid Wic Reset Connect reset key

If the Printer Is Not Detected

• Use a direct USB connection (avoid hubs).
• Restart printer and PC, then try again.
• Try another USB cable (some cables are charge-only).
• Close Epson Status Monitor or other printer utilities.
• Run the app as Administrator.

FAQ