Fix Epson BX600FW Service Required – Waste Counter Reset

Epson BX600FW Waste Ink Counter Reset

The Epson BX600FW delivers reliable printing, but periodic maintenance routines can increase the waste ink counter and eventually trigger a ‘Service Required’ lock.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson BX600FW uses a software counter to estimate pad saturation and locks printing at a set threshold.

What Causes the Epson BX600FW Ink Pad Counter Warning?

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson BX600FW waste counter reset in minutes.

Common Symptoms

  • Printer refuses to print even with ink available
  • Epson Status Monitor shows maintenance warning
  • Blinking lights and blocked jobs
  • Device is locked until reset is performed

Three Steps to Restore Epson BX600FW Printing

  1. Step 1: Use a Windows PC (7–11) with Internet access. Connect Epson BX600FW via USB (Wi-Fi reset is not supported).
  2. Step 2: Start Wic Reset Connect in Administrator mode and wait until Epson BX600FW appears in the device list.
  3. Step 3: Paste the reset key, click Reset, and after completion power-cycle Epson BX600FW.
Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

Most Epson BX600FW waste counter resets finish in ~1–2 minutes.

Troubleshooting

  • Try another USB cable (some cables are charge-only).
  • Use a direct USB connection (avoid hubs).
  • Run the app as Administrator.
  • Temporarily disable VPN/proxy if validation fails.
  • Restart printer and PC, then try again.

FAQ

How long does it take?
Usually about 1–2 minutes.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.

Guide prepared for Epson BX600FW – Waste Ink Counter Reset using Wic Reset Connect.

Shopping Cart