Epson EP-703A Waste Ink Counter Reset

If your Epson EP-703A suddenly refuses to print and shows a maintenance warning, it is often caused by the waste ink (ink pad) counter threshold.

The Epson EP-703A tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Why Does the Epson EP-703A Show ‘Service Required’?

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson EP-703A waste counter reset in minutes.

Common Symptoms

• ‘Service Required’ / service life message in driver or utility
• Maintenance/support code (varies by model/driver)
• Printing stops after cleaning cycles
• Warning repeats after restarting the printer

Reset Epson EP-703A Waste Ink Counter in 3 Steps

1. Βήμα 1: Prepare a Windows PC + USB cable and connect Epson EP-703A directly. Keep Internet enabled for validation.
2. Βήμα 2: Run Wic Reset Connect as Administrator and confirm Epson EP-703A is detected.
3. Βήμα 3: Paste the reset key, click Reset, and after completion power-cycle Epson EP-703A.

Most Epson EP-703A waste counter resets finish in ~1–2 minutes.

System Requirements

• USB connection required (Wi-Fi reset not supported)
• Stable Internet connection during reset
• Valid Wic Reset Connect reset key
• Windows 7/8/10/11 PC

If the Printer Is Not Detected

• Close Epson Status Monitor or other printer utilities.
• Restart printer and PC, then try again.
• Run the app as Administrator.
• Try another USB cable (some cables are charge-only).
• Temporarily disable VPN/proxy if validation fails.