Epson XP-2150 Waste Ink Counter Reset
The Epson XP-2150 is a widely used Epson printer. Like many Epson devices, it can stop printing when the internal waste ink counter reaches its predefined limit.
The Epson XP-2150 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.
What Causes the Epson XP-2150 Ink Pad Counter Warning?
A service visit is often unnecessary. Wic Reset Connect allows a safe Epson XP-2150 waste counter reset in minutes.
Common Symptoms
- ‘Service Required’ / service life message in driver or utility
- Maintenance/support code (varies by model/driver)
- Printing stops after cleaning cycles
- Warning repeats after restarting the printer
Step-by-Step: Epson XP-2150 Waste Counter Reset
- Schritt 1: Connect Epson XP-2150 to a Windows computer with a stable Internet connection using a USB cable.
- Schritt 2: Run Wic Reset Connect as Administrator and confirm Epson XP-2150 is detected.
- Schritt 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson XP-2150.
Most Epson XP-2150 waste counter resets finish in ~1–2 minutes.
What You Need
- Valid Wic Reset Connect reset key
- Stable Internet connection during reset
- USB connection required (Wi-Fi reset not supported)
- Windows 7/8/10/11 PC
Troubleshooting
- Use a direct USB connection (avoid hubs).
- Temporarily disable VPN/proxy if validation fails.
- Close Epson Status Monitor or other printer utilities.
- Try another USB cable (some cables are charge-only).
- Run the app as Administrator.
Frequently Asked Questions
How long does it take?
Usually about 1–2 minutes.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
Guide prepared for Epson XP-2150 – Waste Ink Counter Reset using Wic Reset Connect.